Advertising brake is composed of  chassis and stop pole, it is a traditional way brake with the combination of the modern advertisement machine equipment products, commonly used in residential area, office buildings and the square of the entrance, after on the box body advertisement, let more people understand the contents of advertisements, improve the dispersion scope of advertising, to achieve a kind of forced to convey, but demand for debugging the equipment after the installation, debugging success after the normal work of talents, so how much do we know how to debug it to understand the next small make up after detailed summarize device for everybody how to debug.

How to debug the device of advertisement gate

1. We must use the drill to drill, lock the railing chuck with screws to a certain extent, and prevent the railing chuck from shifting.

2. It can also drill holes in the gear shaft and lock the connecting rod with screws.To avoid accidents!

3. The end face of the gate arm should be on the same plane as the end face of the connecting rod.

4. In many cases, the channel brake can turn the railing to the vertical position so that everyone can adjust the position of the balance arm and rocker arm, so that even if the knuckle bearing is installed, the transmission element can be coated with petroleum jelly for lubrication.This prevents the crux of the matter.

5. If the position of limit switch indicated by the red arrow appears, please adjust it so that the connecting rod can be close to the position of travel limit switch when lifting the machine.This function is for better melting problem!